Battery Testing Facility

Standards Followed :

  • Lead –Acid starter batteries – IEC 60095-1/ SLS 1126: Lead –Acid starter batteries ,Part 1: General requirements and methods of test.
  • Lead-Acid batteries for Motorcycles – JISD 5302:2004: 
  • Lead-Acid Starter Batteries Used For Motor Vehicles and Internal Combustion Engines – UAE.S/GSO 35:2007:

Test carried out  :

Lead-Acid Starter Batteries

Lead –Acid starter batteries

  1. Marking
  2. Acceptance
  3. Retention
  4. Capacity (Effective Capacity & Reserve Capacity)
  5. Cranking-03 cycles
  6. Water Consumption Test
  7. Electrolyte retention
  8. High Rate Discharge
  9. Short circuit current and D.C internal resistance
  10. Life cycle test
Lead-Acid batteries for Motorcycles

Lead-Acid batteries for Motorcycles

  1. Capacity 10hr rate
  2. High rate discharge
  3. Life cycle test (Light Load & Heavy Load)
  4. Water consumption
  5. Charge retention

Other test available

  1. Visual examination and dimension check
  2. Cold cranking ampere (Performance) test
  3. Charge acceptance (Performance) test
  4. Tilt test (Performance) test
  5. Internal resistance test
  6. Road endurance on vehicle (Capacity Check)r
Lead-Acid starter batteries used for motor vehicles and internal combustion engines

Lead-Acid Starter Batteries Used For Motor Vehicles and Internal Combustion Engines

  1. Visual inspection
  2. Checking of materials , construction, packing  and marking
  3. Effective capacity
  4. Rapid discharge (Dry charged)
  5. Rapid discharge (Low Temperature)/cranking
  6. Reserve capacity
  7. Charge acceptance
  8. Rapid discharge Test
  9. Endurance test (Life Cycle Test)
  10. Leakage of air
  11. Water consumption
  12. Electrolyte retention
  13. Heat endurance
  14. Strength